Advantech FWA-3180 Uživatelský manuál

LCM-100 LCD Module User’s Manual

LCM-100 User’s Manual 4

CHAPTER 2 Hardware Installation

LCM-100 User’s Manual 6Chapter 2 Hardware Installation The installation steps are: A. Connect the pow

CHAPTER 3 Demo Tool

LCM-100 User’s Manual 8Chapter 3 Demo Tool It is a tool for DOS and can be run in Windows environment a

CHAPTER 4 Operation Examples

LCM-100 User’s Manual 10Chapter 4 Operation Examples There pages of examples are stored as default data of

11column. F8: ASCII code of string “ABCDEFGHIJ” F9: Command to scroll the displayed string to left hand side for one character. F10: Command to scro

CHAPTER 5 Operating procedure

RS-200-RT User’s Manual iiCopyright This document is copyrighted, 2002, by Advantech Co., Ltd. All right

LCM-100 User’s Manual 14Chapter 5 Operation Procedure There are two parameters to be changed after entering

15string in displaying area. “Page 0” is a demo page to show: 1. Display the string and move it back / forth and up/ down 2. A loop to interrog

LCM-100 User’s Manual 16Scroll 1 character right 28/1C Set display address (position the cursor) location

17row are discontinuous. To change cursor position between upper row and lower row, this command will be applied. Note 2: This command can be use

LCM-100 User’s Manual 18reset itself and send out “reset packet” (0FDH, 0EH) there after. The input must be

iiiProduct Warranty Advantech warrants to you, the original purchaser, that each of its products will be free from defects in materials and workman

RS-200-RT User’s Manual ivallows us to process your return more quickly. 4. Carefully pack the defective

vContents CHAPTER 1 GENERAL INFORMATION... 2 1.2 INTRODUCTION ...

CHAPTER 1General Information

LCM-100 User’s Manual 2 Chapter 1 General Information 1.1 - Introduction The major purpose of this modu

3The power source into this module is 5volt only. There are only three pins being used in the serial port interface: Pin 2: TxD Pin 3: RxD Pin 5: G