Advantech IPC-623 Series Uživatelský manuál Strana 26

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 46
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 25
IPC-623 User Manual 20
Chapter 3 Operation
3.1 The Front Panel of IPC-623
In the middle of the front panel, there is one Power On/Off switch, four
System Reset buttons, and one Alarm Reset button. There are 9 LED
indicators on the lockable front door. Their individual functions are
described as below.
3.1.1 Switch and Buttons
Power On/Off switch: Press this button to turn the system power on or
off.
System Reset button: Press the button to reboot the individual system
(up to four systems).
Alarm Reset button: Whenever a fault occurs in the system (e.g., fan
failure or the temperature in the chassis is too high), the audible alarm
will be activated. Pressing this button will stop the alarm from beeping.
3.1.2 LED indicators for System Status
The LED display on the front door shows a series of indicators which are
grouped into two categories for System Status and Power Status. The fol-
lowing table describes the LED indicators for System Status.
When the system powers is on, the PWR LED is always Green.
When the PWR LED is RED, it indicates a redundant power supply mod-
ule failure. To stop the alarm beep, press the Alarm Reset button. Exam-
ine the redundant power supply module right away and replace the failed
module with a good one.
When the FAN LED is RED, it indicates a failed cooling fan, and the
alarm is also activated. To stop the alarm beep, press the Alarm Reset
button and then replace the failed fan with a good one immediately.
If the TEMP LED is RED, it means that the chassis is overheated. An audi-
ble alarm will be activated. To stop the alarm, press the Alarm Reset button.
Inspect the fan filter and the rear section of the chassis immediately. Make
sure the airflow inside the chassis is not blocked by dust or other particles.
LED Description Green Red
PWR System power Normal Abnormal
FAN Cooling fan status Normal Abnormal
TEMP Temperature in the chassis Normal Abnormal
HDD Hard disk drive activity Data access No light
Zobrazit stránku 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 45 46

Komentáře k této Příručce

Žádné komentáře