Advantech ARK-5280 Uživatelský manuál Strana 36
- Strana / 88
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
ARK-5280 User Manual 20
Chapter 3 Hardware Installation &
Upgrade
3.1 Jumpers and Connectors
The ARK-5280 Embedded Box Computer consists of an Advantech SBC
(Single Board Computer) board that is housed in an aluminum top cover,
a metal chassis with accessed bottom plate. Your CPU, HDD and
SDRAM, are all readily accessible by removing the aluminum top cover.
Any maintenance or hardware upgrades can be easily completed after
removing the top cover or the accessed bottom plate.
3.2 Setting Jumpers
You can configure your ARK-5280 to match the needs of your application
by setting the jumpers. A jumper is the simplest kind of electrical switch.
It consists of two metal pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect them. To “close” a
jumper, you connect the pins with the clip. To “open” a jumper you
remove the clip. Sometimes a jumper will have three pins, labeled 1, 2,
and 3. In this case, you would connect either pins 1 and 2 or pins 2 and 3.
The jumper settings are schematically depicted in this manual as follows:
Warning: Do not remove any mechanical parts, such as the
top cover, or the bottom plate until you have veri-
fied that no power is flowing within the Embedded
Box Computer. Power must be switched off and
the power cord must be unplugged.
- ARK-5280 1
- User Manual 1
- ARK-5280 User Manual ii 2
- ARK-5280 User Manual iv 4
- ARK-5280 User Manual vi 6
- ARK-5280 User Manual viii 8
- ARK-5280 User Manual x 10
- Contents 11
- ARK-5280 User Manual xvi 16
- Overview 17
- Chapter 1 Overview 18
- 1.3 Hardware Specifications 19
- 1.3.4 Audio 20
- 1.3.5 Other 20
- 1.3.6 Storage 20
- 1.3.7 PC Board Expansion 20
- 1.3.8 Mechanical 20
- 5 Chapter 1 21
- ARK-5280 User Manual 6 22
- 1.4 Chassis Dimensions 23
- ARK-5280 User Manual 8 24
- Hardware Functionality 25
- 2.2.1 Power ON/OFF Button 26
- 2.2.2 LED Indicators 26
- 2.2.3 Power Input Connector 27
- 2.2.4 COM2 Connector 27
- 2.2.6 Audio Connector 29
- 2.2.7 DVI Connector 29
- 2.2.10 VGA Connector 32
- 2.2.11 USB Connector 32
- ARK-5280 User Manual 18 34
- Hardware Installation & 35
- 3.1 Jumpers and Connectors 36
- 3.2 Setting Jumpers 36
- 3.3 Jumper Location 37
- 3.5 CMOS Clearance (JP2) 38
- 3.6 PCl Card Power Selection 39
- 3.7 Connecting Power 39
- 4. Insert the SODIMM module 40
- 25 Chapter 3 41
- ARK-5280 User Manual 26 42
- 27 Chapter 3 43
- 3.11 Installing the PCI card 44
- 29 Chapter 3 45
- ARK-5280 User Manual 30 46
- BIOS Setup 47
- Chapter 4 Award BIOS Setup 48
- 4.3 Standard CMOS Setup 49
- 4.4 Advanced BIOS Features 50
- 4.4.1 Virus Warning 51
- 4.4.2 L1 & L2 Cache 51
- 4.4.5 Swap Floppy Drive 51
- 4.4.13 APIC Mode 53
- 4.5.1 DRAM Timing Selectable 53
- 4.5.2 CAS Latency Time 53
- ARK-5280 User Manual 38 54
- 4.5.11 Delayed Transaction 55
- 4.5.12 Delay Prior to Thermal 55
- 4.5.13 AGP Aperture Size (MB) 55
- 4.5.14 On-Chip VGA 55
- 4.5.16 Boot Display 56
- 4.5.17 Panel Scaling 56
- 4.5.18 Panel Resolution 56
- 4.6 Integrated Peripherals 57
- 4.6.3 IDE HDD Block Mode 58
- 4.6.4 USB Controller 59
- 4.6.5 USB 2.0 Controller 59
- 4.6.7 AC97 Audio 59
- 4.6.8 Init Display First 59
- 4.6.9 Onboard FDC Controller 60
- 4.6.10 Onboard Serial Port 60
- 4.6.11 UART Mode Select 60
- 4.6.12 RxD, TxD Active 60
- 4.6.13 IR Transmission Delay 60
- 45 Chapter 4 61
- 4.7 Power Management Setup 62
- 4.7.4 Video Off In Method 63
- 4.7.5 Video Off In Suspend 63
- 4.7.6 Suspend type 63
- 4.7.7 Modem Use IRQ 63
- 4.7.8 Suspend Mode 63
- ARK-5280 User Manual 48 64
- 4.8 PnP/PCI Configurations 65
- 4.9 PC Health Status 66
- 4.9.1 CPU Warning Temperature 67
- 4.9.2 Temperatures/Voltages 67
- 4.9.3 Shutdown Temperature 67
- 4.11 Password Setting 68
- 4.12 Save & Exit Setup 68
- 4.13 Exit Without Saving 68
- PCI-SVGA Setup 69
- Chapter 5 PCI SVGA Setup 70
- 55 Chapter 5 71
- 3. Press the “Next” button 72
- Figure 5.4: License Agreement 73
- 5.3 Further information 74
- Ethernet Interface 75
- 6.1 Introduction 76
- Figure 6.1: Device Manager 77
- Select “Update Driver” 77
- Figure 6.2: Update Driver 78
- Click the “Next” button 78
- Click the “Finish” button 79
- ARK-5280 User Manual 64 80
- Audio Setup 81
- Chapter 7 Audio Setup 82
- Wizard” 83
- ARK-5280 User Manual 68 84
- 69 Chapter 7 85
- ARK-5280 User Manual 70 86
- Watchdog Timer 87
- Appendix A Watchdog Timer 88
Související produkty a manuály pro Barebones pro PC / pracovní stanice Advantech ARK-5280
(39 stránky)
(28 stránky)© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.086 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce