Advantech PCM-3350 Specifikace stáhnout pdf (Strana 9)

Once the model file is ready, save it and press Ctrl+b to build it. Then copy the three files shown in the

below figure into the flash disc.

NOTE: The “Current Folder” tab in the

MATLAB file explorer shows the active

working directory of MATLAB. You must

save all your model files in this folder or

else MATLAB will not know where the

file or its dependencies are. In the example

below ExpMdl is the active folder. So the

model was saved under it and when a build

was performed, all necessary files for

creating executables from C code were

created there. The executables are always

saved under the modelname_xpc_emb

folder. You must copy all these files and

put them into the CF card for your program

to run in Standalone Mode.

Experiment 1.2

Implement the same model used in exp 1.1 with a sample time of 0.01s, but this time use serial

communication to download the file onto the PC104 board.

To do this you need to connect a serial cable (DB-9) from the back of the host computer running

MATLAB to one of the two RS-232 ports on the PC104. The image below shows all the connectors you

will find on the PC104 board. See step 2.2.a to create DOS Loader files.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Žádné komentáře

Advantech PCM-3350 Specifikace Strana 9