Advantech RS-485 Uživatelský manuál stáhnout pdf (Strana 292)

A-2 ADAM-5000

Quick Start Example

This chapter provides guidelines to what is needed to set up and

install a distributed ADAM-5000 network system. A quick hookup

scheme is provided that lets you configure a single system before you

install a network system.

Be sure to carefully plan the layout and configuration of your network

before you start. Guidelines regarding layout are given in Appendix B:

RS-485 Network.

A.1 System Requirements to Setup an ADAM-5000

System

Before you setup an ADAM-5000 system, you can follow the steps to

install I/O modules into the ADAM-5000 base.

1. Align the module with the grooves on the top and bottom of the

base.

2. Push the unit straight into the base until it is firmly seated in the

backplane connector.

3. Push-in the retaining clips at the top and bottom of the unit to

secure the module to the base.

The following list gives an overview of what is needed to setup, install

and configure an ADAM-5000 environment.

• ADAM-5000/485 and I/O Modules

• A host computer, such as an IBM PC/AT compatible, that can

output ASCII characters with an RS-232C or RS-485 port

• Power supply for the ADAM-5000 system (+10 to +30 V

)

• ADAM Series Utility Software

• ADAM Isolated RS-232/RS-485 Converter (optional)

• ADAM Repeater (optional)

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 347 348

Žádné komentáře

Advantech RS-485 Uživatelský manuál Strana 292